C0814 Jeep Auto Trouble Code

C0814 Jeep Auto Trouble Code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

Some problems such as misfires and evaporative emission (EVAP) leaks can be very challenging to nail down. Misfires can be caused by ignition problems, fuel problems or compression problems. The underlying cause might be fouled spark plugs, bad plug wires, a weak ignition coil, dirty injectors, a shorted or open injector, low fuel pressure, a vacuum leak, a leaky head gasket, burned exhaust valve or a camshaft with a bad lobe.

C0814 Jeep Possible Solution:

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

C0814 Jeep Description For All Models :

C0814 Jeep Trouble Repair :

If your C0814 Jeep check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system and engine control unit are in charge of monitoring a bunch of different, and if they get a reading that's a little out of whack, up pops the check engine light.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

Example: 0120